The washer was designed to meet the Canadian Office on Energy Efficiency requirements and to do so it can not offer a warm rinse.

Yes, our UL Safety Certification for Clothes Washers requires testing and reviews to the standard UL2157, which includes a section on plumbing. This cites that the washer does comply with ASSE 1007.

The recommended temperature for the water heater is 130 degrees Fahrenheit.

For a 35lb tumbler—gas consumption per load is 34,853 Btus which is 0.383 cents per load (assumes average cost of natural gas at $1.10 per Therm). Energy to run the motors and control is approximately 0.025 cents per load (assumes

There are many variables to water use. How the owner programs the machine and which cycles are selected by end users will change consumption. The best we can do is provide an estimate based on a commonly used cycle. For

Motors are not interchangeable between phases. The machine you are purchasing will only work on three-phase power.

For a 35-lb tumbler the gas consumption per load is 34,853 BTUs which is $0.383 per load (assumes average cost of natural gas at $1.10 per therm). Energy to run the motors and control is approximately $0.025 per load (assumes

The MEA number used to be required by New York City. The building code has since been revised to state that MEA approvals were not required if the product was certified by a National Recognized Test Lab (NRTL). All of

Mining will need a heavy soil cycle, which is a 45 minute cycle. The light soil cycle time is about 30 minutes. Temperature is completely input dependent on standard no heat models. Cold water input varies greatly by geography and

The most we can say about the unit is that it's probably designed as a 50-pound tumbler. Our best guess is that it was built in the 1960's.