Service/Maintenance Questions – Huebsch Vietnam

My facility runs a Huebsch Originators 75 Model JT75CG gas dryer. Laundry has informed me that it is not drying as fast as it used to. I have looked at the unit and it seems to be operating properly, but I was wondering if you could give me the actual drum operating temp on the high setting.

Answering the question directly, the high temp would be at [...]

Huebsch Team2019-05-01T09:51:06+00:00May 1st, 2019|0 Comments

We have Huebsch Originators Twin 30s and we have discovered that our patrons are getting free dry time if they push two buttons at the same time. Eight minutes of dry time comes up and we are losing money as they are spreading the word to other patrons. How can we reset or stop this from happening?

This will only occur if short (6") money boxes are [...]

Huebsch Team2019-05-01T09:49:40+00:00May 1st, 2019|0 Comments

I have a Huebsch top loading washing machine, model LWZ17NWB3069, which takes approximately 45 minutes to fill with water before the wash cycle commences. Is this normal? Also, recently the linen is coming out still dirty. Is there something obvious I am missing?

Forty-five minutes to fill is not normal, it should take [...]

Huebsch Team2019-05-01T09:48:45+00:00May 1st, 2019|0 Comments

How does a service technician get trained on your machines? We recently took over a commercial contract and need help with these machines.

Click here for our training seminars page to see upcoming events.

Huebsch Team2019-05-01T09:48:00+00:00May 1st, 2019|Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions, Service/Maintenance Questions|0 Comments

I have a Huebsch electric dryer model HDE107WF. My customers are complaining that it doesn’t get hot enough. Most loads are not dry in one cycle. I have checked the duct and it is clear. What else can be done?

How long does the vent run and how many 90 [...]

Huebsch Team2019-05-01T09:46:58+00:00May 1st, 2019|0 Comments

How can I get a copy of the schematics?

All washers have a removable top panel for service. The [...]

Huebsch Team2019-05-01T09:46:02+00:00May 1st, 2019|0 Comments

My store uses Huebsch dryers, model JT0300DFG. I am having an issue. Sometimes when I put coins into the machine, it doesn’t work and the symbol “ERR” displays and blinks. Other times that symbol is gone and returns to normal status.

The coin drop is dirty. Remove, take apart and remove [...]

Huebsch Team2019-05-01T09:44:51+00:00May 1st, 2019|0 Comments

We have a model #JT0350SEL-ser#R0009000117. It shuts off one second after starting. We have cleaned the entire machine but it appears the air flow switch is tripping out. Any suggestions?

If the air flow switch is opening as stated then [...]

Huebsch Team2019-05-01T09:43:36+00:00May 1st, 2019|0 Comments

I have Huebsch dryers and the back of the drums are all turning brown. It looks like it is scorched from the use of fabric softeners. What is the best way to clean it?

Some 409 cleaner and a Brillo pad will remove the [...]

Huebsch Team2019-05-01T09:41:51+00:00May 1st, 2019|0 Comments

We have MDC top load DOE washing machines in our laundry rooms. There are either three or four machines in each laundry room. We are looking to replace the existing hot water tanks with tankless hot water units. The suppliers are not certain of the size of tankless unit to supply either the three or four machine scenario. Can you advise me on the correct tankless sized unit?

The estimated hot water usage is 16 gallons per cycle [...]

Huebsch Team2019-05-01T09:42:27+00:00May 1st, 2019|0 Comments

AMERICAS	EUROPE	APAC
USA Canada Commercial Products Canada Residential Products Latin America	International	China Malaysia Taiwan Thailand South Korea Vietnam Hongkong Indonesia Australia