We have a Huebsch model 42; serial # FT-21039. Yes, it is old but it still works well or at least until today when the blower motor went out. The blower motor is a Marathon, catalog X608, 208 volt, 3 PH and 5.5 amps. Any idea where we can get a replacement motor for this?

2019-07-12T16:49:13+00:00May 1st, 2019||

You will need to contact your nearest distributor who can help you order this part. Please use this form to find your nearest distributor: www.Huebsch.com/locator.

My facility runs a Huebsch Originators 75 Model JT75CG gas dryer. Laundry has informed me that it is not drying as fast as it used to. I have looked at the unit and it seems to be operating properly, but I was wondering if you could give me the actual drum operating temp on the high setting.

2019-05-01T09:51:06+00:00May 1st, 2019||

Answering the question directly, the high temp would be at 180 degrees Fahrenheit. A few things that could cause slow drying: Reduction in make-up air or restrictions in exhaust air due [...]

We have Huebsch Originators Twin 30s and we have discovered that our patrons are getting free dry time if they push two buttons at the same time. Eight minutes of dry time comes up and we are losing money as they are spreading the word to other patrons. How can we reset or stop this from happening?

2019-05-01T09:49:40+00:00May 1st, 2019||

This will only occur if short (6") money boxes are installed which are not long enough to depress the coin vault switch located inside the vault area. An 8" money box [...]

I have a Huebsch top loading washing machine, model LWZ17NWB3069, which takes approximately 45 minutes to fill with water before the wash cycle commences. Is this normal? Also, recently the linen is coming out still dirty. Is there something obvious I am missing?

2019-05-01T09:48:45+00:00May 1st, 2019||

Forty-five minutes to fill is not normal, it should take four to five minutes. Either the water pressure at the location is poor (under 20 psi), or more likely the filter [...]

Go to Top